How to Adjust Carburetor on Poulan Pro Chainsaw Like a Pro

To adjust the carburetor on a Poulan Pro chainsaw, first ensure that the chain is not engaged. Next, remove the air filter cover and carefully pull out the filter element. Then locate the adjustment screws on top of the carburetor- these are usually labeled as H (high speed) and L (low speed). Using a flat […]

How to Take Link Out of Chainsaw Chain

1. Start by turning off the chainsaw. Place it so that you can access the chain and bar easily. 2. Use a tool to loosen and remove the tensioner screw which holds the chain around the bar of your chainsaw, this will release some tension in your chain allowing you to work freely on it. […]

How to Clean a Chainsaw Carburetor?

A chainsaw carburetor is a small, intricate component of the saw that helps mix fuel and air before sending it to the engine. Over time, the carburetor can become clogged with debris or gummed up with old fuel, causing the saw to run poorly or not at all. Cleaning a chainsaw carburetor is a relatively […]

Echo 58 Volt Battery Problems – Causes With Easy Fixes

Echo 58 Volt Battery Problems

One of the most common problems with the Echo 58 Volt battery is that it doesn’t last as long as expected. Many users report having to recharge their batteries more frequently than they anticipated, making it difficult to complete tasks without interruption. Additionally, some users have experienced rapid draining of the battery even when not […]

Stihl Quick Chain Adjuster Problems With Easy Fixes

Stihl Quick Chain Adjuster (QCA) is a device used to quickly and accurately adjust the tension of a chainsaw chain. The most common problem with QCA is when the wheel on the device does not rotate freely, causing it to be difficult or impossible to adjust the chain tension. Other problems include incorrect tightening of […]

Stihl 025 Chainsaw Won’t Start

If the Stihl 025 chainsaw won’t start, there are a few things that could be causing the problem. The most common cause is that the spark plug is fouled or damaged and needs to be replaced. Other possible causes include a dirty air filter, a clogged fuel filter, water in the fuel, or an issue […]

Who Bought Out Olympic Chainsaws – Secret you Should Know

In 1978, the Olympic Company was bought out by McCulloch Corporation. McCulloch was a well-known manufacturer of chainsaws and other outdoor power equipment. The company had been in business since 1943 and had a good reputation for quality products. We all know how important it is to have a dependable chainsaw when tackling those big […]

Chainsaw Won’t Start After Running Out of Gas [Fixed]

If your chainsaw won’t start after running out of gas, there are a few things you can check. First, make sure that the saw is properly fueled and that the spark plug is clean. If the saw still won’t start, try checking the air filter to see if it needs to be replaced. Finally, if […]

Husqvarna 440 Chainsaw Won’T Start

If your Husqvarna 440 chainsaw won’t start, the most likely cause is that it’s out of fuel. Check the fuel tank to make sure there’s gas in it. If it’s empty, fill it up and try starting the chainsaw again. If the tank is full, the problem may be with the carburetor. Try cleaning the […]

How to Test Chainsaw Ignition Coil With Multimeter

To test a chainsaw ignition coil with a multimeter, you’ll need to connect the leads of the multimeter to the primary and secondary terminals on the coil. You should see a reading of around 3 ohms on the multimeter. If the reading is higher or lower than this, it indicates that there may be a […]